MATERIAL SAFETY DATA SHEET
SECTION 1 - IDENTIFICATION
    
PRODUCT NAME: Motion-Plus™ Anti-Friction Grease EMERGENCY TELEPHONE: (786) 336 0630
TRADER OWNER: M & J Sunshine Corporation INFORMATION FAX: (305) 336 0629
TRADER ADDRESS: 5220 NW 72nd Avenue #24
Miami, FL 33166
 
SECTION 2 - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
HAZARDOUS COMPONENTS OSHA PEL ACGIH TLV PERCENT CAS NUMBER
Halogenated N.D. N.D. None 108171-27-3
Lithium 12 Hydroxystearate Sebacate Complex None None 8-12% 68815-49-6
Mineral Oil >3% 500 ppm 5 mg/m3 40-60% 64742-65-0
Mineral Oil >3% 500 ppm 5 mg/m3 25-45% 64742-62-7
Mineral Oil >3% 500 ppm 5 mg/m3 4-6% 64742-52-5
Zinc Oxide None None 0-2% 1314-13-2
SECTION 3 - PHYSICAL/CHEMICAL CHARACTERISTICS
    
BOILING POINT: 500oF
VAPOR PRESSURE (mm Hg): NE
VAPOR DENSITY (air = 1): NE
SOLUBILITY IN WATER: Negligible
APPEARANCE AND ODOR: Smooth cream in color, bland
SPECIFIC GRAVITY: 0.86 @ 16oC
MELTING POINT: 500oF
EVAPORATION RATE: NE
FREEZING POINT: -18oC (0oF)
NLGI NO.: All grades
SECTION 4 - FIRE AND EXPLOSION HAZARD DATA     
    
FLASH POINT AND METHOD USED: 475oF D-92
FLAMMABLE LIMITS: Lower: Not Applicable Upper: Not Applicable
AUTOIGNITION TEMPERATURE: 600oF
EXTINGUISHING MEDIA: CO2, dry chemical, earth and sand
SPECIAL FIRE FIGHTING PROCEDURES: Water may cause frothing
UNUSUAL FIRE AND EXPLOSION HAZARDS: Unknown
SECTION 5 - REACTIVITY DATA
    
STABILITY: Stable under normal conditions.
INCOMPATIBILITY (materials to avoid): Strong Oxidizers.
HAZARDOUS DECOMPOSITION/BYPRODUCTS: Halogens, CO and CO2 if incomplete combustion
HAZARDOUS POLYMERIZATION: Will not occur
CONDITIONS TO AVOID: Open flames
SECTION 6 - HEALTH HAZARD DATA
    
ROUTE(S) OF ENTRY: Inhalation? No. Skin? Yes Ingestion? Yes
HEALTH HAZARDS-ACUTE TOXICOLOGICAL PROPERTIES: Mild skin and eye irritant.
CARCINOGENICITY: None - NTP? No IARC Monographs? No OSHA Regulated? No
SIGNS & SYMPTOMS OF EXPOSURE: Mild irritation and reddening of eyes and sensitive skin
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: None

EMERGENCY AND FIRST AID PROCEDURES:

Eyes: Immediately flush with large quantities of water for at least 15 minutes
Skin Contact: Wash thoroughly with soap and water; remove and launder contaminated clothing
Inhalation: Remove exposed person to fresh air if discomfort is experienced while handling hot product.
Ingestion: Call a physician immediately. Do not induce vomiting.

ADVICE TO PHYSICIANS: High velocity injection under the skin may result in serious injury. If left untreated the affected area is subject to infection, disfigurement, lack of blood circulation and may require amputation. When dispensed by high-pressure equipment, this material can easily penetrate the skin and leave a bloodless puncture wound. Material injected into a finger can be deposited into the palm of the hand. Within 24-48 hours the patient may experience swelling, discoloration and throbbing pain in the affected area. Immediate treatment by a surgical specialist is recommended.

 
SECTION 7 - CONTROL MEASURES
    
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Absorb with sand or inert material; sweep or scoop up and remove.
WASTE DISPOSAL METHOD: Consult federal, state or local authorities for proper disposal procedures. All disposals must comply with federal, state and local regulations.
PRECAUTIONS FOR HANDLING AND STORING: Keep away from sparks and open flames
OTHER PRECAUTIONS: Wash thoroughly after handling with soap and water; do not get in eyes or clothing.
SECTION 8 - PRECAUTIONS FOR SAFE HANDLING AND USE
    
RESPIRATORY PROTECTIONS: None normally required
VENTILATION: Use with adequate ventilation
PROTECTIVE GLOVES: Neoprene, polyethylene, polyvinylchloride, butyl rubber, natural rubber
EYE PROTECTION: Face shield
OTHER PROTECTIVE EQUIPMENT/CLOTHING: None normally required
WORK/HYGIENIC PRACTICES: Wash thoroughly after handling, do not get in eyes or on clothing; keep container closed; keep away from sparks and open flames; good housekeeping conditions.
SECTION 9 - NFPA RATING
    
HEALTH: 0 FIRE: 1 REACTIVITY: 0 SPECIAL: 0
SECTION 10 - TRANSPORTATION
DOT ID No.: N/A
DOT LABEL REQUIRED: None
FREIGHT CLASSIFICATION: Lubricating grease
HAZARD CLASS: Nonhazardous
PACKING GROUP: N/A

The information and recommendations contained herein are based upon data believed to be correct. However, no guarantee or warranty of any kind, expressed or implied, is made with respect to the information contained herein. This Material Safety Data Sheet was prepared to comply with the OSHA Hazard Communication Standard (29 CFR 1910.1200). This supersedes any previous information.